Jack A6F Kataloğu — Sayfa 20

Err-14 DSP Read/Write EEPROM failure Tum off the system power, restart the system after 30 seconds, if it still does not work, Err-15 Motor over-speed protection | please replace the controller and inform the manufacturer. Err-16 Motor reversion HMI Read/Write Err-17 Tum off the system power, restart the system after 30 seconds, if it still does not work, EEPROM failure please replace the controller and inform the manufacturer. Err-18 Motor overload Tum off the system power. Check whether the motor power input plug is off, loose or| E 23 Motor blocked encoder broken, or there is something tangled on the machine head. Please make them correct, tre failure then restart the system. If it still does not work, please inform the manufacturer and replace the controller. 4 Pedal sensitivity adjustment Pedal movement starts from the initial position (p.136) where the motor stops, slowly stepped forward to the low speed point (p.137) where the motor runs at the minimum speed (p.100), proceeding to the accelerated point (p.138) where the motor start fasten, until the max speed point (p.139) where the motor run up to the maximum speed (p.101). And when the pedal steps back to the foot lifter position (p.135), the automatic presser foot lifting. Continuing back to the auto trimming position (p.134), thread trimming is completed automatic. The parameter value is set for an assurance (No. 134 parameters) < (No. 135 parameter) <( No. 136 parameters) <( No. 137 parameters) <( No. 138 parameters) <( No. 139 parameters). Adjusting the corresponding parameters, user can acquire the proper pedal response to fit the personal habit. 136 inital position — 137 low speed 138 accelerated _{ 139 max speed —1——— CSS SS SSN 138 i position 135 foot lifter po: 134 auto trimming Pedal en Fig. 4-1 pedal movement of each position parameter 386P0198F 2017-12-30 8/8