Jack A5 Kataloğu — Sayfa 18

PAB 04 Trimming count Mode-set 0: OFF; : Ascending count, Cycle counting; ; Descending count, Cycle counting; P .enr>- : Ascending count, When the set point is reached, The motor stops running; : Descending count, When the set point is reached, The motor stops running; 3.2 Monitor mode No. Description No. Description 010 stitch counter 025 The sampling voltage of pedal 011 Counter for sewing pieces 026 The ratio between motor and machine 012 The head of real speed 027 The total used time(hours) of motor 013 State of encoder 028 The sampling voltage of interaction 020 DC voltage 029 Software version 021 Machine speed 02A Analog input 1 022 The phase current 02B Analog input 2 023 Initial electrical angle 02¢C Error counter 024 Machine angle 030-037 The history record of error codes 3.3 The warning message Alarm code Description Corrective The stitch counter reaches the limit. Press ®key to cancel the alarm and RLR-C Stitch counter alarm reset the counter. The trimming counter reaches the limit. Press ®keylo cancel the alarm and A İ_ A- 3 Trimming courter alarm reset the counter. P oHa FF Power is off alarm Please wait for 30 seconds, then turn on the power switch Arl UP Safety switch alarm Adjust the machine to the correct position. 3.4 Error mode Ifthe error code appears, please check the following items first: 1.Make sure the machine has been connected correctly; 2. Confirm that the control box match with the machine head. 3. Confirm factory reset is accurate Error Code Description Solution Err-01 Hardware overcurrent Turn off the power switch, and restart after 30 seconds. İf the controller still does not Err-02 Software overcurrent work, please replace it and inform the manufacturer. Disconnect the power to the controller; check the input power supply voltage is low or not (less than 176V). If the power supply voltage is low, please start the controller after Err-03 Under-voltage recovers the voltage. If the controller still does not work, please inform the manufacturer and replace the controller. 6/8