Jack A5 Kataloğu — Sayfa 17

P33 0~100 0 Thread clamp solenoid off time per cycle (ms) P37 0~100 0 Thread clamp solenoid ontime per cycle (ms), means the clamp strength. P45 0~100 1 Back stitch electromagnet per cycle opening time (ms) P46 0-100 2 Back stitch electromagnet per cycle closing time (ms) P47 200-360 360 After trimming anti pull (It realizes trimming is pulled back function) P49 100-500 250 Trimming speed P50 1~500 150 Presser foot lifting electromagnet full output time ms P51 0~100 3 Presser foot lifting electromagnet per cycle opening time (ms) P52 1~800 100 Running delay time when presser footer comes down (ms) Presser foot lifting function selection P53 0n 1 0:off 1:o0n P54 0-100 5 Presser foot lifting electromagnet per cycle closing time (ms) Run to up needle position after Power on: P56 OA 1 0:no action — 1: action P57 0~600 100 Presser foot lifting electromagnet protectiontime 100ms P60 200~5000 3000 The maximum speed of constant sewing (Automatic test speed) Special mode: 0: normal Mode 1: simply sewing mode P62 onDR 0 2: motor initial angle measurement (Do not remove the belt) 3: Automatically setting the pulley ratio by the CPU. (Synchronizer is necessary and the belt not removed) 4: automatic test modle 1 (It has needle stop position of automatic test, running and stopping 58) P66 02 2 Safety switch function set: 2:0n — O:0ff Slow release lifter level adjustment, the smaller values and the faster quickly (OC open P71 0~50 2 time) P76 1-500 60 Back sewing electromagnet full output time ms P78 1~369 120 Start angle P79 0~359 320 End angle PAD 1~-9399 5000 The lift foot release down Delay time after remove cloth when sensing turn on. PA1 0-600 50 The lift foot release down Delay time with cloth when sensing turn on. PAS 02 0 0:All voice 1:0nly pow on voice 2:0nly key-press voice PAG 1~100 1 Needle count Proportion-set PAT 1~-9999 1 Needle count Value-set Needle count Mode-set 0: OFF; 1: Ascending count, Cycle counting; PAB 0~6 0 2: Descending count, Cycle counting; 3: Ascending count, When the set point is reached, The motor stops running: 4; Descending count, When the set point is reached, The motor stops running; PA9 1~100 1 Trimming count Proportion-set PAA 1~-9999 1 Trimming count Value-set 5/8