Jack A5 Kataloğu — Sayfa 16

3 System parameters setting list 3.1 Parameter mode 1. Inthe standby state ,press key to enter the parameter modes. 2, Press corresponding key @@ and key @@ to adjust the corresponding parameter. 3, When the parameter values have increased and decreased, param eter interface flash. Short press ®key to save the modified parameters .Long press key to exit parameter interface, return to standby model. NO. Range Default Description P99 0~2 1 language selection 0: off, 1: Chinese, 2:English, default language 1 Chinese 4000 Po1 200-5000 3500 the maximum speed of free sewing (the global maximum speed) (Heavy Duty) P03 0n 1 Needle stop position selection (0:up; 1: down) Po4 200~3000 1800 Start back tacking speed P05 200~3000 1800 End back tacking speed P06 200~3000 1800 Continuous back sewing speed (W sewing) P07 5~720 300 Clamp start angle when the small nest open P08 0~360 27 Clamp Angle compensation pos oA o Soft start switch (0:0ff; 1: on) POA 100-1200 800 Short trim Speod POB 0-20 1 Short trim needle numbor Poc 0-359 0 Short trim angle Mode of adding stitch P15 0~2 0 0: continuous; 1:half stitch; 2:one stitch P16 09959 30 Adjust the lift foot response time after the sensor has detected the cloth. Automatic induction presser foot sensor setting (between the maximum and minimum P17 0~99 70 value of the 02C parameter display) P18 1~120 35 Stitch balance for start back tacking No.1(Pull in compensation) P19 1~120 20 Stitch balance for start back tacking No.2(Release of compensation) P22 0-50 8 Threshold of the backsewing function off. P24 0-1024 80 Trimming point of pedal P25 1~120 35 Stitch balance for end back tacking No.1 P26 1-120 20 Stitch balance for end back tacking No.2 P27 0172 1 Presser Foot sensor mode setting: 0: off 1:turn on only after trimming 2: always ON P30 0-31 0 Feedforward torque of motor: — 0: normal functions — 1-31: feedforward torque level P31 10~199 50 Trimming afterburner coefficient (motor afterburner) P32 1~500 400 Thread clamp solenoid full open time (ms) 4/8